Results 1 to 8 of 8
Thread: Site Plan Bearings Input
Threaded View
-
04-05-2006, 08:10 AM #1Registered User Promoted
- Join Date
- Dec 2005
- Location
- Connecticut
- Posts
- 55
Site Plan Bearings Input
Hi all,
I'm working on drawing the boundary lines from a current site plan i have on paper. I have no problem with straight lines, however, one side of my lot is mainly a combination of lines & curves.
On the plan I am given the "Curve Data" with information that i believe to be
Radius
Delta (given as an angle)
Arc Length
Tangent Length
CH: (chord length i believe?)
Could someone please give me some suggestions on what of the information I need & how to go about inputing it so as to create my boundary lines? I'd greatly appreciate the feedback.
Thanks,
Dan